The Cytac Shotgun Shell Carrier is an easy to install shotshell carrier that holds six 12-gauge shotgun shells for faster reloading and increased ammunition capacity. This side saddle fits Mossberg pump shotguns like the 500, 590, 590DA, etc.
INSTALLATION GUIDE
1. Remove 6 little hex screws from the shotshell carrier to expose two tapped holes in the mounting plate.
2. Lay the shotgun on its side with the election port facing down.
3. Using the supplied big screw with washer, push out the pin located above and to the rear of the trigger guard (leave the screw in the hole).
4. Turn the shotgun over and place the mounting plate on the receiver with the two corresponding holes on the two screws.
5. Starts inserting the screws into the mounting plate and hand tighten (do NOT overtighten). Overtightening may lock up the shotgun's action. To troubleshoot, simply loosen the screws.
- Lightweight,polymer shotshell carrier
- Easy installation,requires no alterations to the shotgun in most cases
- All mounting screws are included,no gunsmithing required
- Holds 6x 12-gauge shotgun shells
No returns without prior approval and Return Authorization (RA) as-provided by Valken Sports. Returns and returns-for-credit or replacement are processed on a case-by-case basis at the discretion of Valken Sports. Please note that any warranty, service, or repair on any non-Valken brand product must be coordinated with the manufacturer directly. Valken does not provide support, service or repair for AirUps LLC, Alkin, Custom Chrono, DYE, Enola Gaye, GoG Paintball, Habervision, HK Army, HTR - Exalt, J&J, GelBlaster LLC, Planet Eclipse LLC, Push Paintball, Sig Sauer, Umarex USA, and United Tactical Systems (First Strike).
